SIDE AIRBAG SENSOR(for Front Door) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL DOOR SIDE AIRBAG SENSOR LH


    1. Check that the engine switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:


      • B006BY6

        Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

      • B006AIG

        If this procedure is performed without disconnecting the negative (-) battery terminal, the airbag may deploy even if an impact is applied only to the door side airbag sensor LH. Therefore, make sure that the negative (-) battery terminal is disconnected before performing this procedure.

    3. Connect the airbag connector.

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.


      1. Before connecting the connector, check that the position of the housing lock is correct as shown in the illustration.

        B006EG6C29
        *a Correct *b Incorrect
        *c CPA *d Housing

      2. While holding the CPA be sure to engage the connectors until they are locked and check that the CPA is in its original position (when locking, make sure that a click sound can be heard).

        Note

        Do not push down the upper part of the CPA shown in the illustration when connecting the airbag connector.

        B006DZFC31
        *a CPA Upper Part *b Housing Lock
        *c CPA *d Connection is Completed
    4. B006AXCC01
      B006DHE Install in this Direction

      Attach the claw to hold the door side airbag sensor LH in place.

    5. Install a new nut.

      Torque:
      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

      Note


      • If the door side airbag sensor LH has been dropped, replace it with a new one.

      • When installing the door side airbag sensor LH, be careful that the SRS wiring does not interfere with or is not pinched between other parts.

      • Do not reuse the nut.

    6. Check that there is no looseness in the installation parts of the door side airbag sensor LH.

  2. INSTALL FRONT DOOR SERVICE HOLE COVER LH

    Click here

  3. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  4. INSTALL COURTESY LIGHT ASSEMBLY

    Click here

  5. INSTALL FRONT DOOR NO. 2 ARMREST COVER LH

    Click here

  6. INSTALL FRONT DOOR ARMREST COVER LH

    Click here

  7. INSTALL FRONT DOOR UPPER TRIM COVER LH

    Click here

  8. INSPECT FITTING OF FRONT DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    for 8GR-FKS:

    Click here

    for V35A-FTS:

    Click here

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  10. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

    Click here

  11. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  12. CHECK SRS WARNING LIGHT

    Click here