OIL PRESSURE SENSOR INSTALLATION

PROCEDURE

  1. INSTALL OIL PRESSURE SENSOR

    1. Apply Toyota Genuine CVT fluid FE to the O-ring.

      Note:

      If reusing the oil pressure sensor, check that the O-ring is not damaged.

    2. C273903C02

      *a

      Length of SST 50 mm (1.97 in.)

      *b

      Length of Torque Wrench 180 mm (7.09 in.)

      Using SST, install the oil pressure sensor to the continuously variable transaxle assembly.

      09326-22011

      without SST [Torque (N*m(kgf*cm, ft.*lbf))]

      20.6 N*m

      210 kgf*cm

      15 ft.*lbf

      with SST [Reading of Torque wrench (N*m(kgf*cm, ft.*lbf))]

      16.1 N*m

      164 kgf*cm

      12 ft.*lbf

      Tip:

      • This torque value is effective when SST is parallel to the torque wrench.

      • The "with SST" torque value is effective when using SST with a fulcrum length of 50 mm (1.97 in.).

      • The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 180 mm (7.09 in.).

      • If using a torque wrench with a different length, or connecting the torque wrench and SST at an angle, refer to the alternate torque values.

        Click here

    3. Connect the oil pressure sensor connector.

  2. INSPECT FOR FLUID LEAK

  3. INSTALL REAR ENGINE UNDER COVER LH (for 1ZR-FAE)

    Click here

  4. INSTALL REAR ENGINE UNDER COVER LH (for 1ZR-FE)

    Click here

  5. INSTALL REAR ENGINE UNDER COVER LH (for 2ZR-FE)

    Click here

  6. INSTALL NO. 1 ENGINE UNDER COVER (for Half Cover Type)

  7. INSTALL NO. 1 ENGINE UNDER COVER (for Full Cover Type)

    Click here

  8. INSTALL NO. 1 ENGINE UNDER COVER (for Metal Type)

  9. INSTALL FRONT WHEEL LH (for 1ZR-FAE)

    Click here

  10. INSTALL FRONT WHEEL LH (for 1ZR-FE, 2ZR-FE)

    Click here

  11. RESET MEMORY

    Click here