STARTER (for 2.0 kW Type) REMOVAL


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE FRONT FENDER SEAL


    1. Remove the 5 clips and front fender seal.

  4. DISCONNECT CLUTCH RELEASE CYLINDER ASSEMBLY

    A01E1IKE01

    1. Remove the 2 bolts and disconnect the release cylinder.

  5. REMOVE STARTER ASSEMBLY


    1. A01E1QM

      Detach the wire harness clamp and remove the bolt to disconnect the wire harness.

    2. A01DYT7

      Disconnect the starter connector.

    3. Disconnect the terminal cap.

    4. Remove the nut and disconnect the starter wire.

    5. A01E08V

      Remove the bolt and disconnect the clutch flexible hose bracket.

    6. Remove the bolt and starter assembly.