POWER WINDOW REGULATOR MOTOR(for Hatchback Front Side, Wagon Front Side) REMOVAL

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for both the RH and LH sides.

  • The procedure described below is for the LH side.

PROCEDURE

  1. PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click hereClick hereClick hereClick here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick hereClick hereClick hereClick hereClick here

  3. REMOVE DOOR ASSIST GRIP ASSEMBLY

    Click hereClick here

  4. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

    Click hereClick here

  5. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

    Click hereClick here

  6. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH

    Click hereClick here

  7. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY

    Click hereClick here

  8. REMOVE FRONT DOOR SERVICE HOLE COVER

    1. w/ Front No. 1 Speaker:

      1. B334201

        Disconnect the connector.

    2. Remove the front door service hole cover.

      Click hereClick here

  9. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY

    Click hereClick here

  10. REMOVE FRONT DOOR WINDOW REGULATOR ASSEMBLY

    Click hereClick here