FRONT SEAT OUTER BELT ASSEMBLY REMOVAL

  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Click here.

  2. REMOVE LUGGAGE TRIM SERVICE HOLE COVER

    1. Disengage the claw to remove the luggage trim service hole cover.

      A011YZM

  3. DISCONNECT CABLE FROM AUXILIARY BATTERY NEGATIVE TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE FRONT DOOR SCUFF PLATE

    1. Disengage the 10 claws and remove the front door scuff plate LH.

      A011XE7

  5. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP

    1. Disconnect the front door opening trim weatherstrip.

  6. REMOVE REAR DOOR SCUFF PLATE

    1. Disengage the 6 claws and remove the rear door scuff plate LH.

      A011YC1

      Tech Tips

      Disengage the claws from the rear side of the scuff plate.

  7. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP

    1. Disconnect the rear door opening trim weatherstrip.

  8. REMOVE LAP BELT OUTER ANCHOR COVER

    1. Disengage the 3 claws and remove the lap belt outer anchor cover.

      A011X7P

  9. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY

    1. Remove the bolt and disconnect the floor anchor of the front seat outer belt assembly.

      A011Y0O

  10. REMOVE CENTER PILLAR LOWER GARNISH

    1. Disengage the 2 claws and 3 clips, and remove the center pillar lower garnish LH.

      A011VGE

  11. REMOVE CENTER PILLAR UPPER GARNISH

    1. Remove the 2 screws.

      A011YV5

    2. Disengage the clip.

    3. Pass the floor anchor of the front seat outer seat belt assembly LH through the center pillar upper garnish LH and remove the center pillar upper garnish LH.

  12. REMOVE FRONT SEAT OUTER BELT ASSEMBLY

    1. Remove the nut and disconnect the shoulder anchor of the front seat outer belt assembly.

      A011XOZ

    2. Using a screwdriver, pull out the locking button in the direction shown by the arrow in the illustration to release the lock, and disconnect the pretensioner connector as shown in the illustration.

      A011XI6E01
      Text in Illustration
      *1 Protective Tape

      Tech Tips

      Tape the screwdriver tip before use.

    3. Remove the 2 bolts and front seat outer belt assembly.

      A011YJZ

  13. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY

    1. Remove the 2 bolts.

      A011XW3

    2. Disengage the guide and remove the front shoulder belt anchor adjuster assembly.