REAR SEAT SIDE AIRBAG ASSEMBLY INSTALLATION

Tech Tips

  • Use the same procedure for the LH side and RH side.

  • The procedure listed below is for the LH side.

  1. INSTALL REAR SEAT AIRBAG ASSEMBLY

    CAUTION:

    • The nuts must not be reused.

    • Make sure that the rear side seatback frame sub-assembly is not deformed. If it is, replace it with a new one.

    1. Install the rear seat airbag assembly to the rear side seatback frame sub-assembly with 2 new nuts.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

    2. Engage the clamp to connect the airbag wire harness.

    3. for LH Side:

      1. Engage the 7 hooks to install the rear side seatback cover with pad.

    4. for RH Side:

      1. Engage the 8 hooks to install the rear side seatback cover with pad.

  2. INSTALL REAR NO. 2 SEAT COVER BEZEL (for LH Side)

    1. Install the rear No. 2 seat cover bezel to the rear side seatback frame sub-assembly LH with the 4 screws.

      A011Y9A

  3. INSTALL REAR SEAT SHOULDER BELT GUIDE

    1. Engage the guide.

      A011VXL

    2. Install the rear seat shoulder belt guide LH to the rear side seatback assembly LH with the 2 screws.

  4. INSTALL REAR SIDE SEATBACK ASSEMBLY

    1. Engage the hook to install the rear side seatback assembly LH.

    2. Install the 2 bolts.

      Torque:
      18 N*m  { 184 kgf*cm, 13 ft.*lbf }

    3. Connect the connector.

    4. Connect the rear seat outer belt to the rear seat shoulder belt guide LH.

  5. INSTALL REAR SEAT CUSHION LOCK HOOK

    1. Engage the claw to install a new rear seat cushion lock hook.

      A011WOT

      Note

      Rear seat cushion lock hooks must not be reused.

      Tech Tips

      Use the same procedure for the RH side and the LH side.

  6. INSTALL REAR SEAT CUSHION ASSEMBLY

    1. Place the rear seat cushion assembly in the cabin.

      Note

      Be careful not to damage the vehicle body.

    2. Engage the 2 hooks of the seat cushion to the vehicle body as shown in the illustration.

      A011VFP

    3. Confirm that the seat cushion is firmly installed.

      Note

      When installing the seat cushion, make sure that the seat belt buckles are not under the seat cushion.

  7. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  8. INSTALL LUGGAGE TRIM SERVICE HOLE COVER

    1. Engage the claw to connect the luggage trim service hole cover.

  9. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  10. INSPECT SRS WARNING LIGHT

    Click here