METER / GAUGE SYSTEM DATA LIST / ACTIVE TEST

  1. DATA LIST

    Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    Note

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    1. Warm up the engine.

    2. Turn the power switch off.

    3. Connect the Techstream to the DLC3.

    4. Turn the power switch on (IG).

    5. Turn the Techstream on.

    6. Enter the following menus:

      1. for Combination Meter: Body Electrical / Combination Meter / Data List.

      2. for ABS/VSC/TRAC: Chassis / ABS/VSC/TRAC / Data List.

      3. for Engine and ECT: Powertrain / Engine and ECT / Data List.

      4. for Main Body: Body Electrical / Main Body / Data List.

    7. Check the values by referring to the table below.

      Combination Meter
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Tail Relay SW Tail relay/OFF or ON OFF: Tail relay off -
      ON: Tail relay on
      ODO/TRIP Change SW ODO/TRIP change switch/OFF or ON OFF: Switch released -
      ON: Switch pushed
      P-Seatbelt Buckle SW Front passenger seat belt buckle switch/OFF or ON OFF: Front passenger seat belt fastened (warning light off) -
      ON: Front passenger seat belt unfastened (warning light on)
      Vehicle Speed Meter Vehicle speed/Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph) Almost the same as actual vehicle speed -
      Engine Rpm Engine speed/Min.: 0 rpm, Max.: 12750 rpm 900 to 1050rpm: Idling -
      Coolant Temperature Engine coolant temperature/-40 to 127.5°C (-40 to 261.5°F) After warming up: 75 to 100°C (167 to 212°F)

      • After warming up the engine, the engine coolant temperature is 75 to 100°C (167 to 212°F).

      • After a long soak, the engine coolant temperature, intake air temperature and ambient air temperature are approximately equal.
      Washer Switch Washer fluid level warning switch/OFF or ON OFF: Washer fluid level not low -
      ON: Washer fluid level low
      Light Control Switch Light control switch/OFF or ON OFF: Light control switch off -
      ON: Light control switch not off
      Multi Display Select Switch DISP switch in the steering pad switch LH*1 or the steering pad switch assembly*2/OFF or ON OFF: DISP switch in the steering pad switch LH*1 or the steering pad switch assembly*2 not pressed -
      ON: DISP switch in the steering pad switch LH*1 or the steering pad switch assembly*2 pressed
      +B Voltage Value Auxiliary battery voltage/Min.: 0 V, Max.: 25.5 V 11 to 16 V -
      Integrated Value for Oil Maintenance*3 Maintenance required reminder value/Min.: 0, Max.: 25500 (mile) Driving distance after performing maintenance required reminder reset procedure displayed If the value is 5000 (miles) or more, perform the maintenance required reminder reset procedure after performing maintenance.
      Fuel Input Fuel input/Min.: 0, Max.: 127.5 Fuel receiver gauge indicates F: 57.0 Unit: Liter
      Fuel receiver gauge indicates 3/4: 48.3
      Fuel receiver gauge indicates 1/2: 32.2
      Fuel receiver gauge indicates 1/4: 16.1
      Fuel receiver gauge indicates E: 6.4
      Ambient Temperature Outside temperature/Min.: -40°C (-40°F), Max.: 87.5°C (189.5°F) Almost the same as actual outside temperature The temperature displayed on the multi-information display is -40 to 50°C (-40 to 122°F)
      HV System Indicator Hybrid system indicator value/ Min.: -512, Max.: 511 -512 to 511 -
      Oil Pressure Switch Oil pressure switch/OFF or ON OFF: Engine started -
      ON: Engine not started
      Turn Signal Switch (Right) RH turn signal switch/OFF or ON OFF: RH turn signal switch off -
      ON: RH turn signal switch on
      Turn Signal Switch (Left) LH turn signal switch/OFF or ON OFF: LH turn signal switch off -
      ON: LH turn signal switch on
      Hazard Flasher Switch Hazard warning switch/OFF or ON OFF: Switch released -
      ON: Switch pushed
      Headlight Auto Leveling Switch*4 Headlight auto leveling control/OFF or ON OFF: Headlight auto level control off -
      ON: Headlight auto level control on
      Vehicle Approach Warning Switch Vehicle proximity notification system switch/OFF or ON OFF: Switch released Not applicable
      ON: Switch pushed
      Key Remind Sound Cycle of the key reminder warning buzzer/Normal, Slow, Fast Normal, Slow, Fast -
      Driver Side Seatbelt Warning Buzzer Condition of the driver seat belt warning buzzer/OFF or ON OFF: The seat belt warning buzzer does not sound at the vehicle speed of 20 km/h (12 mph) or more when the driver seat belt unfastened Displays customize setting of driver seat belt warning buzzer
      ON: The seat belt warning buzzer sounds at the vehicle speed of 20 km/h (12 mph) or more when the driver seat belt unfastened
      P-Seatbelt Warning Buzzer Condition of the front passenger seat belt warning buzzer/OFF or ON OFF: The seat belt warning buzzer does not sound at the vehicle speed of 20 km/h (12 mph) or more when the front passenger seat belt unfastened Displays customize setting of front passenger seat belt warning buzzer
      ON: The seat belt warning buzzer sounds at the vehicle speed of 20 km/h (12 mph) or more when the front passenger seat belt unfastened
      Number of Trouble Code The number of the DTC currently stored/0 to 255 0 -

      • *1: w/o Navigation System

      • *2: w/ Navigation System

      • *3: with mph units

      • *4: w/ Automatic Headlight Beam Level Control System

      ABS/VSC/TRAC
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Vehicle Speed Maximum wheel speed sensor reading/Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) Vehicle stopped: 0 km/h (0 mph) When driving at constant speed: No large fluctuations
      Engine and ECT
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Injection Volum (Cylinder 1) Injection volume (cylinder 1)/Min.: 0 ml, Max.: 2.047 ml 0 to 0.5 ml

      • Stored as freeze frame data

      • This is the fuel injection volume for 10 injections.
      Coolant Temp Coolant temperature/Min.: -40°C (-40°F), Max.: 140°C (284°F) 75 to 100°C (167 to 212°F): After warming up

      • Stored as Freeze Frame Data

      • This is the engine coolant temperature.

      Tech Tips

      • After warming up the engine, the engine coolant temperature is 75 to 100°C (167 to 212°F).

      • After a long soak, the engine coolant temperature, intake air temperature and ambient air temperature are approximately equal.

      • If the value is -40°C (-40°F), or higher than 135°C (275°F), the sensor circuit is open or shorted.

      • Check if the engine overheats when the value indicates higher than 135°C (275°F).

      Note

      Enter inspection mode Click here.

      Main Body
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Illumination Rate Info Illumination rate information/0 ms. to 2162.65 ms. Value output according to ambient light level -

  2. ACTIVE TEST

    Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

    1. Connect the Techstream to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the Techstream on.

    4. Enter the following menus: Body Electrical / Combination Meter / Active Test.

    5. Check the operation by referring to the table below.

      Combination Meter
      Tester Display Test Part Control Range Diagnostic Note
      Speed Meter Operation Speedometer 0, 40, 80, 120 mph*1 -
      0, 40, 80, 120, 160, 200, 240 km/h*2
      Tacho Meter Operation Tachometer 0, 1000, 2000, 3000, 4000, 5000, 6000, 7000 (rpm) -
      Fuel Meter Operation Fuel receiver gauge EMPTY, 1/2, FULL -
      Fuel Consumption Meter Operation Fuel consumption meter OFF, MIN., 1/4, 1/2, 3/4, MAX. -
      A/T Indicator Operation 1 Shift indicator (P, R, N, D, 4, 3, 2, L) OFF or ON -
      A/T Indicator Operation 2 Shift indicator (S, 6, 5) OFF or ON -
      A/T Indicator Operation 3 Shift indicator (D) OFF or ON Sports mode
      Indicat. Lamp Airbag SRS warning light OFF or ON -
      Indicat. Lamp Doors All Open Door indicator light OFF or ON -
      Driver Side Seat Belt Seat belt warning light OFF or ON -
      Indicat. Lamp ABS ABS warning light OFF or ON -
      Indicat. Lamp Charge Charge warning light OFF or ON -
      Indicat. Lamp Slip Slip indicator light OFF or ON -
      Indicat. Lamp Beam High beam indicator light OFF or ON -
      Indicat. Lamp Head*1 Head indicator light OFF or ON -
      Indicat. Lamp Tail*2 Tail indicator light OFF or ON -
      Indicat. Lamp Fr FOG Front fog indicator light OFF or ON -
      Indicat. Lamp Rr FOG*3, *4 Rear fog indicator light OFF or ON Not applicable
      Indicat. Lamp Fuel Fuel level warning light OFF or ON -
      VSC TRC Indicator TRAC OFF or TRC OFF indicator light OFF or ON -
      Indicat. Tire Pressure Warning System*5 Tire pressure warning light OFF or ON -
      Indicat. Lamp ECB Electronically controlled brake system warning light OFF or ON -
      Indicat. Oil Pressure Oil pressure warning light OFF or ON -
      Indicat. Lamp Cruise Cruise control indicator light OFF or ON -
      Indicat. Lamp Brake Brake warning light OFF or ON -
      Indicat. EPS EPS warning light OFF or ON -
      Master Warning Master warning light OFF or ON -
      Indicat. Ready (HV) Ready indicator light OFF or ON -
      Indicat. EV Mode EV indicator light OFF or ON -
      Indicat. SET SET indicator light OFF or ON -
      Indicat. VSC OFF VSC off indicator light OFF or ON -
      Indicat. ECO Mode Eco mode indicator light OFF or ON -
      EV Mode Indicator EV drive mode indicator light OFF or ON -
      Turn Signal (Left) Indicator LH turn indicator light OFF or ON -
      Turn Signal (Right) Indicator RH turn indicator light OFF or ON -
      Water temperature meter operation Engine coolant temperature receiver gauge Low, Normal, High -
      HV System Indicator Hybrid system indicator MIN, -50, 0, 100, 200, 300, 400, MAX -
      Meter Display 1 Multi-information display / LCD display OFF, 0, 1, 2, 3, 4, 5, 6, All *6
      Meter Display 2 LCD display OFF, 7, 8, 9 -

      • *1: with mph units

      • *2: with km/h units

      • *3: w/ Rear Fog Light

      • *4: Although the item is displayed on the Techstream, it is not applicable to this vehicle.

      • *5: w/ Tire Pressure Warning System

      • *6: The multi-information display operates only when All is selected for Control Range.