ELECTRICAL KEY OSCILLATOR (for Front Floor) REMOVAL

  1. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY

    1. Turn the shift lever knob sub-assembly counterclockwise and remove the shift lever knob sub-assembly.

      A011XO8

  2. REMOVE FRONT PANEL GARNISH LH

    1. Disengage the 3 claws, 2 clips and 8 guides to remove the front panel garnish LH.

      A011YNG

  3. REMOVE FRONT PANEL GARNISH RH

    1. Disengage the 3 claws, 2 clips and 8 guides to remove the front panel garnish RH.

      A011X5F

  4. REMOVE REAR CONSOLE UPPER PANEL SUB-ASSEMBLY

    1. Open the upper console panel sub-assembly door.

    2. Move the shift lever to N.

    3. Disengage the 4 clips.

      A011W2O

    4. Disconnect each connector and remove the rear console upper panel sub-assembly.

  5. REMOVE UPPER CONSOLE BOX SUB-ASSEMBLY

    1. Remove the 2 screws.

      A011VX0

    2. Disengage the 4 clips and 2 guides remove the upper console box sub-assembly as shown in the illustration.

      A011XIX

    3. Disengage the clamp.

      A011X8H

    4. Disconnect the connector to remove the upper console box sub-assembly.

  6. REMOVE NO. 4 CONSOLE BOX DUCT

    1. Disengage the claw and remove the No. 4 console box duct.

      A011VST

  7. REMOVE NO. 1 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY

    1. Disengage the clamp.

      A011VXD

    2. Remove the bolt.

    3. Disconnect the connector and remove the No. 1 indoor electrical key antenna assembly.

      Note

      Be careful when removing the indoor electrical key antenna assembly. If the antenna is dropped, replace it with a new one.