INTEGRATION RELAY REMOVAL

  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Click here.

  2. REMOVE LUGGAGE TRIM SERVICE HOLE COVER

    1. Disengage the claw to remove the luggage trim service hole cover.

      A011YZM

  3. DISCONNECT CABLE FROM AUXILIARY BATTERY NEGATIVE TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE NO. 1 RELAY BLOCK COVER

    1. Disengage the 2 claws and remove the No. 1 relay block cover as shown in the illustration.

      A011VYC

  5. REMOVE ENGINE ROOM JUNCTION BLOCK ASSEMBLY

    1. Disengage the 2 claws as shown in the illustration.

      A011Y32E03
      Text in Illustration
      *1 Protective Tape - -
      *a Pulled Position - -

    2. Using pliers, pull up the engine room junction block assembly at the position indicated in the illustration and disconnect the 4 connectors from the engine room relay block assembly.

      Note

      When pulling a engine room junction block assembly, take care not to damage the engine room junction block assembly.

      Tech Tips

      Tape the pliers tip before use.

    3. Disconnect the 2 connectors and remove the engine room junction block assembly.

      A011Y87

      Note

      • Do not drop or allow any impact on parts.

      • Do not touch the connector.