CLEARANCE SONAR MAIN SWITCH REMOVAL

  1. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH

    1. Disconnect the front door opening trim weatherstrip LH.

      A011Y5J

  2. REMOVE INSTRUMENT SIDE PANEL LH

    1. Using a moulding remover, disengage the 4 claws as shown in the illustration.

      A011XLO

    2. Disengage the 3 guides and remove the instrument side panel LH as shown in the illustration.

      A011YUQ

  3. REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH

    1. Disengage the 3 clips to remove the No. 1 instrument cluster finish panel garnish as shown in the illustration.

      A011YEK

  4. REMOVE NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY

    1. Apply protective tape to the area shown in the illustration.

      A011YBME01
      Text in Illustration
      *1 Protective Tape

    2. Disengage the 2 clips as shown in the illustration.

      A011WKW

    3. Using a moulding remover, disengage the 2 clips to remove the No. 1 instrument panel register assembly.

      A011X53

  5. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

    1. Operate the tilt and telescopic lever to fully extend and lower the steering column assembly.

    2. Using a moulding remover, disengage the 2 claws, 4 clips and 2 guides.

      A011WPT

    3. Disengage the 5 claws, 5 clips and 2 guides.

      A011XB4

    4. Disconnect each connector.

    5. Remove the instrument cluster finish panel assembly as shown in the illustration.

      A011YPC

  6. REMOVE BACK SONAR OR CLEARANCE SONAR SWITCH ASSEMBLY

    1. Disengage the 2 claws and remove the back sonar or clearance sonar switch assembly.

      A011Y2P