PARKING ASSIST MONITOR SYSTEM Guide Lines are Displayed with Vehicle Center Line

DESCRIPTION

The rear television camera assembly can create parking guide lines. Because this function is not necessary on vehicles with the parking assist monitor system, the guide line creation function of the rear television camera assembly is disabled.

WIRING DIAGRAM

A011VR6E01

INSPECTION PROCEDURE

Note

  • When "System initializing" is displayed on the navigation ECU sub-assembly after disconnecting the cable from the negative (-) auxiliary battery terminal, correct the steering angle neutral point Click here.

  • Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed Click here.

PROCEDURE

  1. CHECK SCREEN MODE

    1. Check the back guide monitor screen.

      A011WDQE01
      Result
      Result Proceed to
      Guide lines are displayed with vehicle center line. A
      Guide lines are displayed without vehicle center line. B
      Text in Illustration
      *a Vehicle Center Line
    B

    USE SIMULATION METHOD TO CHECK (A WIRE MAY BE OPEN) Click here

    A

  2. CHECK HARNESS AND CONNECTOR (REAR TELEVISION CAMERA ASSEMBLY - BODY GROUND)

    1. Disconnect the T6 connector from the rear television camera assembly.

      A011WBKE01

      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        T6-1 (CURT) - Body ground Always Below 1 Ω
        Text in Illustration
        *a

        Front view of wire harness connector

        (to Rear Television Camera Assembly)
    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    REPLACE REAR TELEVISION CAMERA ASSEMBLY Click here