NOISE FILTER ON-VEHICLE INSPECTION

  1. INSPECT RADIO SETTING CONDENSER (for High Mounted Stop Light)

    1. With the radio setting condenser installed, check that there is no looseness or other abnormalities.

    2. Remove the bolt.

    3. Disengage the clamp and disconnect the radio setting condenser with wire harness from the vehicle body.

    4. Measure the resistance and voltage of the radio setting condenser according to the value(s) in the table below.

      Note

      Before measuring the resistance and voltage, be sure to use insulated probes to avoid a short circuit between the tester terminal and bracket.

      A011WULE01
      Standard Resistance
      Tester Connection Condition Specified Condition
      1 - 2

      • Power switch off

      • High mounted stop light off

      • Window defogger off

      • Luggage compartment room light off

      		 10 kΩ or higher
      1 - 3 10 kΩ or higher
      1 - Body ground Below 1 Ω
      Standard Voltage
      Tester Connection Condition Specified Condition
      2 - Body ground

      • Power switch on (IG)

      • High mounted stop light off

      • Window defogger off

      • Luggage compartment room light off

      		 Below 1 V
      3 - Body ground Below 1 V
      2 - Body ground

      • Power switch on (IG)

      • High mounted stop light on

      • Window defogger on

      • Luggage compartment room light on

      		 11 to 14 V
      3 - Body ground 11 to 14 V
      Text in Illustration
      *a Radio Setting Condenser

  2. INSPECT RADIO SETTING CONDENSER (for Window Defogger)

    1. With the radio setting condenser installed, check that there is no looseness or other abnormalities.

    2. Remove the bolt.

    3. Disengage the 2 clamps and disconnect the radio setting condenser with wire harness from the vehicle body.

    4. Measure the resistance and voltage of the radio setting condenser according to the value(s) in the table below.

      A011W1GE01
      Standard Resistance
      Tester Connection Condition Specified Condition
      1 (+B) - 2 (GND)

      • Power switch off

      • High mounted stop light off

      • Window defogger off

      • Luggage compartment room light off

      		 10 kΩ or higher
      3 - Body ground Below 1 Ω
      Standard Voltage
      Tester Connection Condition Specified Condition
      1 - Body ground

      • Power switch on (IG)

      • High mounted stop light off

      • Window defogger off

      • Luggage compartment room light off

      		 Below 1 V
      1 - Body ground

      • Power switch on (IG)

      • High mounted stop light on

      • Window defogger on

      • Luggage compartment room light on

      		 11 to 14 V
      Text in Illustration
      *a Radio Setting Condenser