POWER STEERING SYSTEM CALIBRATION

  1. ASSIST MAP WRITING (USING THE TECHSTREAM)

    1. Turn the power switch off.

    2. Connect the Techstream to the DLC3.

    3. Turn the power switch on (IG).

    4. Turn the Techstream on.

    5. Enter the following menus: Chassis / EMPS / Utility / Signal Check.

      Tech Tips

      • Follow the instructions on the Techstream to perform Signal Check.

      • With DTC C1581/26 output, performing Signal Check will cause the power steering ECU assembly to enter Test Mode and the assist map will be written automatically.

    6. Wait for at least 5 seconds.

    7. Check for DTCs Click here.

      Tech Tips

      After writing the assist map, if DTC C1581/26 is output, perform the troubleshooting procedure for DTC C1581/26 Click here.

  2. ASSIST MAP WRITING (USING SST CHECK WIRE)

    1. Turn the power switch off.

      A011Y8CE07

    2. Using SST, connect terminals 12 (TS) and 4 (CG) of the DLC3.

      SST
      09843-18040

      Note

      Connect the terminals correctly to avoid a malfunction.

    3. Turn the power switch on (IG).

    4. Wait for 5 seconds or more.

    5. Check for DTCs Click here.

      Tech Tips

      After writing the assist map, if DTC C1581/26 is output, perform the troubleshooting procedure for DTC C1581/26 Click here.

      Text in Illustration
      *1 DLC3