INPUT SHAFT OIL SEAL REPLACEMENT

  1. REMOVE HYBRID VEHICLE TRANSAXLE ASSEMBLY

    Click here

  2. REMOVE INPUT SHAFT TYPE T OIL SEAL

    1. Using a screwdriver with its tip taped, remove the input shaft type T oil seal.

      A011W73E01
      Text in Illustration
      *a Vinyl Tape

      Note

      When removing the input shaft type T oil seal, make sure not to damage the input shaft or hybrid vehicle transaxle housing.

  3. INSTALL INPUT SHAFT TYPE T OIL SEAL

    1. Coat the lip of a new input shaft type T oil seal with MP grease.

      A011YS4E01
    2. Using SST and a hammer, tap in the input shaft type T oil seal.

      SST
      09388-40010
      Oil seal installation depth
      1.0 to 1.8 mm (0.0394 to 0.0709 in.)

      Note

      • Ensure that no foreign matter adheres to the input shaft type T oil seal lip.

      • Ensure that the input shaft type T oil seal is not at an angle.

  4. INSTALL HYBRID VEHICLE TRANSAXLE ASSEMBLY

    Click here