POWER SWITCH INSPECTION

  1. INSPECT POWER SWITCH

    1. Measure the resistance according to the value(s) in the table below.

      A011Z2FE01
      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      5 (SS1) - 6 (GND) Not pushed 10 kΩ or higher
      1 (SS2) - 6 (GND)
      5 (SS1) - 6 (GND) Pushed Below 1 Ω
      1 (SS2) - 6 (GND)

      If the result is not as specified, replace the power switch.

    2. Apply battery voltage between the terminals of the switch, and check the illumination condition of the power switch.

      A011Z2FE04
      Text in Illustration
      *a Indicator Light

      Tech Tips

      • If a positive (+) battery lead and a negative (-) battery lead are incorrectly connected, the power switch indicator light will not illuminate.

      • If the voltage is too low, the indicator light will not illuminate.

      OK
      Measurement Condition Specified Condition

      Battery positive (+) → Terminal 9 (SWIL)

      Battery negative (-) → Terminal 6 (GND)

      		 Illuminates

      If the result is not as specified, replace the power switch.