VACUUM SENSOR REMOVAL

  1. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

    1. Lift the rear of the engine cover to detach the cover from the 2 pins, and then lift the front of the engine cover to detach the cover from the pin and remove the No. 1 engine cover sub-assembly.

      A011WEI

      Note

      Attempting to disengage both front and rear clips at the same time may cause the No. 1 engine cover sub-assembly to break.

  2. REMOVE MANIFOLD ABSOLUTE PRESSURE SENSOR

    1. Disconnect the connector.

      A011WEH

    2. Disconnect the vacuum hose.

      A011X9H

    3. Remove the bolt and manifold absolute pressure sensor.