COMBINATION SWITCH INSPECTION

  1. INSPECT EV DRIVE MODE SWITCH (PATTERN SELECT SWITCH ASSEMBLY)

    1. Measure the resistance according to the value(s) in the table below.

      A011XJEE01
      Standard Resistance
      Tester Connection Condition Specified Condition
      I48-4 (S) - I48-1 (E) EV drive mode switch (pattern select switch assembly) being pushed and held Below 1 Ω
      I48-4 (S) - I48-1 (E) EV drive mode switch (pattern select switch assembly) not pushed 10 kΩ or higher
      Text in Illustration
      *a

      Component without harness connected

      (EV Drive Mode Switch (Pattern Select Switch Assembly))

      If the result is not as specified, replace the EV drive mode switch (pattern select switch assembly).

    2. Apply Auxiliary battery voltage between the terminals of the switch, and check the illumination condition of the pattern select switch assembly.

      A011XJEE03
      Standard Resistance
      Measurement Condition Specified Condition
      Auxiliary battery positive (+) → I48-3 (ILL+) Auxiliary battery negative (-) →I48-2 (ILL-) Illuminates
      Text in Illustration
      *a

      Component without harness connected

      (EV Drive Mode Switch (Pattern Select Switch Assembly))

      If the result is not as specified, replace the EV drive mode switch (pattern select switch assembly).