RELAY ON-VEHICLE INSPECTION

  1. INSPECT IGNITION CONTROL RELAY (IGCT)

    1. Measure the resistance according to the value(s) in the table below.

      A011YL6E01
      Standard Resistance
      Tester Connection Condition Specified Condition
      3 - 5 Auxiliary battery voltage is not applied between terminals 1 and 2 10 kΩ or higher
      3 - 5 Auxiliary battery voltage is applied between terminals 1 and 2 Below 1 Ω
      Text in Illustration
      *1 Ignition Control Relay

      If the result is not as specified, replace the relay.

  2. INSPECT HYBRID WATER PUMP RELAY (INV W/PMP)

    1. Measure the resistance according to the value(s) in the table below.

      A011WO3E05
      Standard Resistance
      Tester Connection Condition Specified Condition
      3 - 5 Auxiliary battery voltage is not applied between terminals 1 and 2 10 kΩ or higher
      3 - 5 Auxiliary battery voltage is applied between terminals 1 and 2 Below 1 Ω
      Text in Illustration
      *1 Hybrid Water Pump Relay

      If the result is not as specified, replace the relay.