REAR CRANKSHAFT OIL SEAL INSTALLATION

  1. INSTALL REAR ENGINE OIL SEAL

    1. Apply MP grease to the lip of a new oil seal.

      Note

      • Do not allow foreign matter to contact the lip of the oil seal.

      • Do not allow MP grease to contact the dust seal.

    2. Using SST and a hammer, tap in the oil seal until its surface is flush with the edges of the cylinder block and crankcase.

      A011VRVE01
      SST
      09223-15030
      09950-70010   ( 09951-07150 )

      Note

      • Keep the lip of the oil seal free from foreign matter.

      • Do not tap in the oil seal at an angle.

  2. INSTALL FLYWHEEL SUB-ASSEMBLY

    1. Using SST, hold the crankshaft.

      A011WGUE04
      SST
      09213-54015
      91551-80650
      09330-00021

    2. Apply a few drops of adhesive to 2 or 3 threads at the tip of each of the 8 bolts.

      A011XP9E03
      Text in Illustration
      *1 Adhesive
      Adhesive
      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

    3. Install and uniformly tighten the 8 bolts in the sequence shown in the illustration.

      A011WMJE02
      Torque:
      130 N*m  { 1326 kgf*cm, 96 ft.*lbf }

      Note

      Do not start the engine for at least an hour after installing the flywheel sub-assembly.

    4. Check that the crankshaft turns smoothly.

  3. INSTALL TRANSMISSION INPUT DAMPER ASSEMBLY

    1. Using SST, hold the crankshaft.

      A011WGUE04
      SST
      09213-54015
      09330-00021
      91551-80650

    2. Install the transmission input damper assembly.

    3. Install and uniformly tighten the 6 bolts in the sequence shown in the illustration.

      A011Z6RE02
      Torque:
      30 N*m  { 306 kgf*cm, 22 ft.*lbf }

      Note

      • Take care not to insert the transmission input damper assembly in the wrong direction.

  4. INSTALL HYBRID VEHICLE TRANSAXLE ASSEMBLY

    Click here