HYBRID BATTERY SYSTEM, Diagnostic DTC:P0A95-123

DTC Code DTC Name
P0A95-123 High Voltage Fuse

DESCRIPTION

DTC No. INF Code DTC Detection Condition Trouble Area
P0A95 123 Voltage between VB8 and VB9 terminals is below the standard despite the interlock switch being engaged (1 trip detection)

  • Service plug grip

  • HV battery

WIRING DIAGRAM

A011VG9E03

INSPECTION PROCEDURE

CAUTION:

  • Before inspecting the high-voltage system, take safety precautions to prevent electrical shocks, such as wearing insulated gloves and removing the service plug grip. After removing the service plug grip, put it in your pocket to prevent other technicians from accidentally reconnecting it while you are working on the high-voltage system.

  • After removing the service plug grip, wait for at least 10 minutes before touching any of the high-voltage connectors or terminals. After waiting for 10 minutes, check the voltage at the terminals in the inspection point in the inverter with converter assembly. The voltage should be 0 V before beginning work Click here.

    Tech Tips

    At least 10 minutes is required to discharge the high-voltage capacitor inside the inverter with converter assembly.

  • When disposing of an HV battery, make sure to return it through an authorized collection agent who is capable of handling it safely. If the HV battery is returned via the manufacturer specified route, it will be returned properly and in a safe manner by an authorized collection agent.

Note

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Click here.

PROCEDURE

  1. CHECK DTC OUTPUT (HYBRID CONTROL)

    1. Connect the Techstream to the DLC3.

    2. Turn the power switch on (IG).

    3. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.

    4. Read output DTCs Click here.

      Result
      Result Proceed to
      P0AFC-123 is not output. A
      P0AFC-123 is also output. B

    5. Turn the power switch off.

    6. Disconnect the Techstream from the DLC3.

    B

    GO TO DTC CHART (P0AFC-123) Click here

    A

  2. CHECK SERVICE PLUG GRIP

    1. Turn the power switch off.

    2. Check that the service plug grip is not installed.

      Note

      After removing the service plug grip, do not turn the power switch on (READY), unless instructed by the repair manual because this may cause a malfunction.

    3. Measure the resistance according to the value(s) in the table below.

      A011YR1E01
      Standard Resistance
      Tester Connection Standard Resistance
      Service plug grip Below 1 Ω
    NG

    REPLACE SERVICE PLUG GRIP Click here

    OK

    REPLACE HV BATTERY Click here

  3. REPLACE SERVICE PLUG GRIP

    Click here

    NEXT

  4. RECONFIRM DTC OUTPUT (HYBRID CONTROL)

    1. Connect the Techstream to the DLC3.

    2. Turn the power switch on (IG).

    3. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.

    4. Read output DTCs Click here.

      Result
      Result Proceed to
      DTCs are not output. A
      DTCs are also output. B

    5. Disconnect the Techstream from the DLC3.

    B

    GO TO DTC CHART (HYBRID CONTROL SYSTEM) Click here

    A

    RECOVERY TO NORMAL