HYBRID CONTROL SYSTEM, Diagnostic DTC:P0A1A-166

DTC Code DTC Name
P0A1A-166 Generator Control Module

DESCRIPTION

The MG ECU located in the inverter with converter assembly monitors its internal operation and it will set DTCs when it detects malfunctions. If any of the following DTCs are output, replace the inverter with converter assembly.

DTC No. INF Code DTC Detection Condition Trouble Area
P0A1A 166 R/D converter NM stop error Inverter with converter assembly

MONITOR DESCRIPTION

The MG ECU performs many diagnostic tests to verify proper operation of internal ECU systems. In this diagnostic monitor, the MG ECU checks for an R/D (Resolver/Digital Converter) malfunction involving the generator resolver. If MG ECU detects an R/D error, it will conclude that there is an internal malfunction involving the generator resolver. The power management control ECU will illuminate the MIL and set a DTC.

MONITOR STRATEGY

Related DTCs P0A1A (INF 166): R/D converter NM signal stop abnormality
Required sensors / components Inverter with converter assembly (MG ECU)
Frequency of operation Continuous
Duration TMC's intellectual property
MIL operation 1 driving cycle
Sequence of operation None

TYPICAL ENABLING CONDITIONS

The monitor will run whenever the following DTCs are not present TMC's intellectual property
Other conditions belong to TMC's intellectual property -

TYPICAL MALFUNCTION THRESHOLDS

TMC's intellectual property -

COMPONENT OPERATING RANGE

Power management control ECU DTC P0A1A (INF 166) is not detected

CONFIRMATION DRIVING PATTERN

A011WPQE01

  1. Connect the Techstream to the DLC3.

  2. Turn the power switch on (IG) and turn the Techstream on.

  3. Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).

  4. Turn the power switch off.

  5. Turn the power switch on (READY) and allow MG2 to rotate at 50 rpm or more for 30 seconds, then turn the power switch off. [A]

  6. Repeat [A] 3 times. [B]

  7. Turn the power switch on (IG) and turn the Techstream on.

  8. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes. [C]

  9. Check that permanent DTCs are cleared.

  10. If the permanent DTCs are not cleared, perform the universal trip, and then check for permanent DTCs again.

Tech Tips

  • If a permanent DTC is output, the system is malfunctioning.

  • If no permanent DTC is output, the system is normal.

INSPECTION PROCEDURE

PROCEDURE

  1. REPLACE INVERTER WITH CONVERTER ASSEMBLY

    Click here

    NEXT

    COMPLETED