HYBRID CONTROL SYSTEM, Diagnostic DTC:P060B-134, P060B-135, P060B-570

DTC Code DTC Name
P060B-134 Internal Control Module A/D Processing Performance
P060B-135 Internal Control Module A/D Processing Performance
P060B-570 Internal Control Module A/D Processing Performance

DESCRIPTION

The power management control ECU monitors its internal operation and it will set this DTC when it detects an internal malfunction. If this DTC is output, replace the power management control ECU.

DTC No. INF Code DTC Detection Condition Trouble Area
P060B 134 ECU internal error Power management control ECU
135
570

MONITOR DESCRIPTION

The power management control ECU performs diagnostic tests to verify proper operation of internal ECU systems. One of these monitors the rationality of internal analog (signal) to digital conversions. The power management control ECU monitors the internal A/D (Analog/Digital converter) value. If there is an A/D converter malfunction, the power management control ECU will illuminate the MIL and set a DTC.

MONITOR STRATEGY

Related DTCs P060B (INF 134/135/570): Internal control module A/D processing performance
Required sensors / components Power management control ECU
Frequency of operation Continuous
Duration TMC's intellectual property
MIL operation Immediately
Sequence of operation None

TYPICAL ENABLING CONDITIONS

The monitor will run whenever the following DTCs are not present TMC's intellectual property
Other conditions belong to TMC's intellectual property -

TYPICAL MALFUNCTION THRESHOLDS

TMC's intellectual property -

COMPONENT OPERATING RANGE

Power management control ECU DTC P060B (INF 134/135/570) is not detected

CONFIRMATION DRIVING PATTERN

A011XPYE01

  1. Connect the Techstream to the DLC3.

  2. Turn the power switch on (IG) and turn the Techstream on.

  3. Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).

  4. Turn the power switch off.

  5. Turn the power switch on (READY) and after a few seconds, turn the power switch off. [A]

  6. Repeat [A] 3 times. [B]

  7. Turn the power switch on (IG) and turn the Techstream on.

  8. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes. [C]

  9. Check that permanent DTCs are cleared.

  10. If the permanent DTCs are not cleared, perform the universal trip, and then check for permanent DTCs again.

Tech Tips

  • If a permanent DTC is output, the system is malfunctioning.

  • If no permanent DTC is output, the system is normal.

INSPECTION PROCEDURE

PROCEDURE

  1. REPLACE POWER MANAGEMENT CONTROL ECU

    Click here

    NEXT

    COMPLETED