ECM INSTALLATION

  1. INSTALL NO. 1 ECM BRACKET

    1. Install the No.1 ECM bracket with the nut.

      Torque:
      12 N*m  { 122 kgf*cm, 9 ft.*lbf }

    2. Connect the wire harness clamp.

    3. Install the wire harness and 2 clamps.

    4. Install the nut.

  2. INSTALL NO. 1 RELAY BLOCK COVER

  3. INSTALL ECM

    1. Install the No.2 ECM brackets to the ECM with the 2 screws.

      A011Z13
      Torque:
      3.0 N*m  { 31 kgf*cm, 27 in.*lbf }

    2. Temporarily install the screw (B).

    3. Install the ECM with the nut.

      A011YW2E01
      Torque:
      12 N*m  { 122 kgf*cm, 9 ft.*lbf }

    4. Install the screw (A).

      Torque:
      3.0 N*m  { 31 kgf*cm, 27 in.*lbf }

    5. Tighten the screw (B).

      Torque:
      3.0 N*m  { 31 kgf*cm, 27 in.*lbf }

    6. Connect the 2 ECM connectors and lower the 2 levers.

      A011YKK

      Note

      • When connecting the connectors, make sure that dirt, water or other foreign matter does not become stuck between the connectors and other part.

      • Make sure that the 2 levers are securely locked.

    7. Connect the 2 wire harness clamps.

  4. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  5. INSTALL LUGGAGE TRIM SERVICE HOLE COVER

    1. Engage the claw to connect the luggage trim service hole cover.

  6. PERFORM INITIALIZATION

    Click here