SIDE TURN SIGNAL LIGHT ASSEMBLY REMOVAL

Tech Tips

  • Use the same procedure for the RH and LH sides.

  • The procedure described below is for the LH side.

  1. REMOVE OUTER REAR VIEW MIRROR

    1. Apply protective tape to the areas shown in the illustration.

      A011WRRE01
      Text in Illustration
      *1 Protective Tape

    2. Push the upper part of the mirror surface and tilt it.

    3. Using a moulding remover, disengage the 2 claws at the lower part of the outer rear view mirror as shown in the illustration.

      A011VD7E01
      Text in Illustration
      *1 Moulding Remover

    4. Disengage the 2 guides as shown in the illustration.

      A011WJD

    5. Disconnect the 2 connectors and remove the outer rear view mirror.

      A011XF0

  2. REMOVE OUTER MIRROR COVER

    1. Remove the 3 screws.

      A011W67

    2. Disengage the clamp.

      A011YY2

    3. Disconnect the 2 connectors and remove the mirror actuator.

    4. Disengage the 7 claws and remove the outer mirror cover.

      A011YXJ

  3. REMOVE SIDE TURN SIGNAL LIGHT ASSEMBLY

    1. Disengage the 2 claws.

      A011XK7

    2. Disconnect the connector and remove the side turn signal light assembly.