SLIDING ROOF HOUSING DISASSEMBLY

  1. REMOVE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY

    1. Disengage the claw.

      A011W71E01
      Text in Illustration
      *1 Guide
      *2 Pin

    2. Disengage the guide and pin, and remove the map light bracket.

    3. Remove the 2 bolts and sliding roof drive gear sub-assembly.

      A011WKX

  2. REMOVE SUNSHADE TRIM SUB-ASSEMBLY

    1. Remove the screw and sliding roof piece sub-assembly LH.

      A011Y0P

      Tech Tips

      Use the same procedure for the RH side.

    2. Slide and remove the sunshade trim sub-assembly.

      A011XX8

  3. REMOVE REAR SLIDING ROOF PANEL

    1. Disengage the 2 claws. Then slide the rear sliding roof panel rearward to remove it.

      A011XSIE01

  4. REMOVE SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY

    Note

    Do not disassemble the sliding roof drive cable sub-assembly except when replacing it.

    1. Hold down the roof wind deflector panel sub-assembly.

      A011YOA

    2. Using a screwdriver, slide the sliding roof drive cable sub-assembly in the direction indicated by the arrow in the illustration to remove it.

      A011Y5ZE01
      Text in Illustration
      *1 Protective Tape

      Tech Tips

      • Tape the screwdriver tip before use.

      • Use the same procedure for the other sliding roof drive cable sub-assembly.

  5. REMOVE ROOF WIND DEFLECTOR PANEL SUB-ASSEMBLY

    1. Pull the spring in the direction indicated by the arrow (1) in the illustration to disengage the 2 springs.

      A011XZJE01
      Text in Illustration
      *1 Spring
      *2 Guide

    2. Pull the roof wind deflector panel sub-assembly in the direction indicated by the arrow (2) in the illustration to disengage the 2 guides and remove it.