POWER WINDOW REGULATOR MOTOR (for Front Door) INSPECTION

INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

1. Apply positive (+) auxiliary battery voltage to connector terminal 2 (B).

   

   Note

   Do not apply positive (+) auxiliary battery voltage to any terminals other than terminal 2 (B) to avoid damaging the pulse sensor inside the motor.

2. Connect a negative (-) auxiliary battery to connector terminals 1 (E) and 7 (DWN1) or 10 (UP1).

3. Check that the motor gear rotates smoothly as follows:

   OK

   Measurement Condition Specified Condition Connect a positive (+) auxiliary battery lead to terminal 2 (B), connect a negative (-) auxiliary battery lead to terminal 1 (E), and keep them connected for 3 seconds or more. With terminals 2 (B) and 1 (E) connected, connect a negative (-) auxiliary battery lead to terminal 10 (UP1). Disconnect and reconnect the negative (-) auxiliary battery lead for terminal 10 (UP1) within 1 second. Motor gear rotates clockwise Connect a positive (+) auxiliary battery lead to terminal 2 (B), connect a negative (-) auxiliary battery lead to terminal 1 (E), and keep them connected for 3 seconds or more. With terminals 2 (B) and 1 (E) connected, connect a negative (-) auxiliary battery lead to terminal 7 (DWN1). Disconnect and reconnect the negative (-) auxiliary battery lead for terminal 7 (DWN1) within 1 second. Motor gear rotates counterclockwise

   Text in Illustration

   *a	Component without harness connected (Power Window Regulator Motor Assembly LH)
   *b	Counterclockwise
   *c	Clockwise

   • If the result is not as specified, replace the power window regulator motor assembly LH.

   Note

   Reset the power window regulator motor (initialize the pulse sensor) after installing the power window regulator motor and regulator assembly.

INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH

1. Apply auxiliary battery voltage to the motor connector according to the table below.

   

   Note

   Do not apply auxiliary battery voltage to any terminals except terminals 1 and 2.

   Standard
   Measurement Condition Specified Condition Auxiliary battery positive (+) → Terminal 1 Auxiliary battery negative (-) → Terminal 2 Motor gear rotates clockwise Auxiliary battery positive (+) → Terminal 2 Auxiliary battery negative (-) → Terminal 1 Motor gear rotates counterclockwise

   Text in Illustration

   *a	Component without harness connected (Power Window Regulator Motor Assembly RH)
   *b	Motor Gear
   *c	Clockwise
   *d	Counterclockwise

   If the result is not as specified, replace the power window regulator motor assembly RH.