FRONT EVAPORATOR TEMPERATURE SENSOR INSTALLATION

INSTALL NO. 1 COOLER THERMISTOR

1. Install the No. 1 cooler thermistor as shown in the illustration.

   

   Part	Length
   A	34.3 mm	1.35 in.
   B	20.9 mm	0.82 in.
   C	50 mm	1.96 in.

   Text in Illustration

   *a	Fixed Part
   *b	Sensor Part

   Note

   • Be sure to insert the thermistor only once because reinserting it into the same position will not allow it to be firmly secured.

   • When reusing the evaporator, insert the thermistor one row next to the one that has been used previously (X in the illustration).

   • After inserting the thermistor, do not apply excessive force to the wire.

   • Directly insert the thermistor until the edge of plastic case "a" comes into contact with evaporator "b".

2. Engage the 2 clamps.