ROOM TEMPERATURE SENSOR REMOVAL

  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Click here.

  2. REMOVE LUGGAGE TRIM SERVICE HOLE COVER

    1. Disengage the claw to remove the luggage trim service hole cover.

      A011YZM

  3. DISCONNECT CABLE FROM AUXILIARY BATTERY NEGATIVE TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE FRONT DOOR SCUFF PLATE LH

    1. Disengage the 10 claws and remove the front door scuff plate LH.

      A011XE7

  5. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH

    1. Remove the clip.

      A011XOP

    2. Pull the cowl side trim sub-assembly LH in the direction indicated by the arrow shown in the illustration to disengage the 2 clips and remove the cowl side trim sub-assembly LH.

  6. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH

    1. Disconnect the front door opening trim weatherstrip LH.

      A011Y5J

  7. REMOVE INSTRUMENT SIDE PANEL LH

    1. Using a moulding remover, disengage the 4 claws as shown in the illustration.

      A011XLO

    2. Disengage the 3 guides and remove the instrument side panel LH as shown in the illustration.

      A011YUQ

  8. REMOVE FRONT PANEL GARNISH LH

    1. Disengage the 3 claws, 2 clips and 8 guides to remove the front panel garnish LH.

      A011YNG

  9. DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

    1. Disengage the claw and 2 guides to disconnect the hood lock control lever sub-assembly.

      A011Y3J

  10. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL ASSEMBLY

    1. Remove the bolt <C> and screw <D> or <E>.

      A011XNW

    2. Disengage the 4 claws, 9 clips and 3 guides to remove the lower No. 1 instrument panel finish panel assembly.

      A011VRM

  11. REMOVE ROOM TEMPERATURE SENSOR (COOLER THERMISTOR)

    1. Disengage the 2 claws as shown in the illustration.

      A011VUJ

    2. Disconnect the hose and connector and remove the room temperature sensor (cooler thermistor).