BRAKE CONTROL SYSTEM


  1. CONSTRUCTION


    1. The brake control power supply is used as an auxiliary power source, in order to supply power to the brake system in a stable manner.

    2. The brake control power supply assembly contains 6 capacitor cells, which store an electrical charge provided by the (12 V) vehicle power supply. When the voltage of the (12 V) vehicle power supply drops, the electrical charge stored in the capacitor cells is used as an auxiliary power supply for the brake system.

      Figure 1. Brake Control Power Supply Assembly

      A004CK8C04
      *1 Capacitor Cell *2 Control Board
      *3 Connector - -

      Tech Tips

      Immediately after the power switch (push start switch) is turned off, this brake power supply assembly is in the discharging state, and some voltage remains in the capacitors. Therefore, make sure to check for residual voltage and discharge it if necessary, before removing the brake control power supply assembly from the vehicle or opening and inspecting the inside of the brake control power supply assembly case. For details, refer to the Repair Manual.