PRE-COLLISION SYSTEM


  1. OPERATION


    1. The combination meter assembly uses the multi-information display, master warning light, PCS warning light and multi buzzer to provide the driver with pre-collision system warnings and indications.

      A001M0JC01
      *1 Combination Meter Assembly - -
      *a Multi-information Display *b Master Warning Light
      *c PCS Warning Light *d VSC OFF Indicator Light

    2. If the millimeter wave radar sensor assembly determines that the possibility of a collision is high, it sends a signal to the combination meter assembly. Upon receiving this signal, the combination meter assembly indicates a warning using the multi-information display. Details are indicated below.

      When there is a high possibility of a collision
      Multi-information Display PCS Warning Light
      BRAKE! -

    3. When the system is not available, the following warning occurs to warn the driver.

      When a system malfunction is detected
      Multi-information Display Detail Master Warning Light PCS Warning Light Multi Buzzer
      Pre-Collision System Malfunction. Visit Your Dealer. This message appears when the forward recognition camera (camera sensor) or millimeter wave radar sensor assembly detects a system malfunction. Illuminates Flashes Sounds once
      Pre-Collision System Unavailable. Temperature or power supply of millimeter wave radar sensor assembly is abnormal. - Illuminates -
      Pre-Collision System Unavailable. Clean Sensor. Dirty center mark of upper radiator grille or millimeter wave radar sensor assembly. - Illuminates -
      Front Camera Unavailable. Temperature or power supply of forward recognition camera (camera sensor) is abnormal. - Illuminates -
      Front Camera Vision Blocked. Clean and Demist Windshield. Dirty or fog windshield glass over the forward recognition camera (camera sensor). - Illuminates -
      When the pre-collision system is turned OFF
      Multi-information Display Detail Master Warning Light PCS Warning Light Multi Buzzer
      Pre-Collision System Off. Pre-collision system operation is disabled. - Illuminates -
      When in VSC OFF mode
      Multi-information Display Detail Master Warning Light PCS Warning Light VSC OFF Indicator Light
      VSC Turned Off. Pre-Collision Brake System Unavailable. Pre-collision braking and pre-collision brake assist operation is disabled (a warning that occurs when there is a high possibility of a collision is still enabled). - Illuminates Illuminates

      Tech Tips

      The message appears for 6 seconds on the multi-information display.

    4. The pre-collision system can be turned ON/OFF at setting display of the multi-information display.


      1. On the setting display screen, select PCS icon and then press on Enter/Set switch on the steering pad switch assembly.

      2. Select [PCS] and then press on Enter/Set switch on the steering pad switch assembly. Each time is pressed, the system will be enabled/disabled.

        A001M0HC01
        *1 Combination Meter Assembly *2 Steering Pad Switch Assembly
        *a Enter/Set Switch *b PCS Warning Light
        *c Multi-information Display - -

        Tech Tips


        • If the system is disabled, the PCS warning light will turn on and a message will be displayed on the multi-information display.

        • The system is automatically enabled each time the power switch is turned to on (IG or READY).

    5. The pre-collision warning timing can be changed on setting display of the multi-information display.


      1. On the setting display screen, select PCS icon and then press on Enter/Set switch on the steering pad switch assembly.

      2. Select [Sensitivity] and then press on Enter/Set switch on the steering pad switch assembly. Each Enter/Set switch is pressed, operation timing (Far/Middle/Near) of the pre-collision system will be changed.

        A001LNZC01
        *1 Combination Meter Assembly *2 Steering Pad Switch Assembly
        *a Enter/Set Switch *b Multi-information Display
        *c Far *d Middle
        *e Near - -