LIGHTING SYSTEM

OUTLINE

SPECIFICATION

*1: Models with halogen type headlight

*2: Models with LED type headlight

*3: Models with halogen type front fog light

*4: Models with LED type front fog light

*5: Models with Australia

*6: Models with rear fog light

PRECAUTION

1. Automatic High Beam System (Models with Automatic High Beam System)

   
   

   1. The automatic high beam system is a system that helps enhance visibility by automatically turning the high beams on and off.

   2. However, due to control limitations of the automatic high beam system, it may be necessary to manually turn the high beams on and off. When driving, for safety reasons, make sure to change the high beams and low beams manually according to the driving conditions.

   3. Under the following conditions, the automatic high beam system might not detect other vehicles or lights correctly, or the high beams might cause glare or flash pedestrians or the occupants of other vehicles. Manual operation should be used.

      Factor	Condition
      Weather/Climate	When driving in bad weather (rain, snow, fog, sandstorms, etc.). When the temperature in the cabin is very high.
      Windshield Glass	When the windshield glass is not clear (ice, snow or frost on the glass). When the windshield glass is dirty (sand, mud, water stains or bugs on the glass). When the windshield glass is cracked. When the windshield glass is fogged-up. When the windshield glass has a film attached. When an object on the instrument panel reflects off of the windshield glass. When any other abnormal conditions exist with the windshield glass.
      Forward Recognition Camera (Camera Sensor)	When the forward recognition camera (camera sensor) is deformed. When the forward recognition camera (camera sensor) is dirty. When any other abnormal conditions exist with the forward recognition camera (camera sensor).
      Nearby Vehicles or Lights	When lights similar to headlights or taillights are in the vicinity of the vehicle. When a nearby vehicle has no lights or its lights are off. When a vehicle in front has misaligned lights, or its lights are changing color. When a vehicle in front has extremely dirty headlights or taillights.
      Road Conditions	When driving in an area where the conditions often change between bright and dark. When driving on a road with many uphill and downhill slopes. When driving on a winding road or around a sharp curve. When driving on a bumpy road (cobblestone pavement, gravel road, rough unpaved road, etc.). When highly reflective objects are in front of the vehicle (mirrors, road signs, etc.).
      Vehicle Conditions	When the headlights are damaged, deformed or dirty. When the vehicle posture is abnormal due to flat tire (or posture has changed due to the vehicle being fully loaded, a trailer being towed, etc.). When the vehicle has other malfunctions or if the vehicle has been modified.
      Automatic High Beam System	Malfunction: When the automatic high beam indicator light on the combination meter assembly is blinking or not illuminating. Others: When the Automatic High Beam system does not seem to be changing between the high beams and low beams properly. When the Automatic High Beam system is frequently changing between the high beams and low beams. When the glare from the high beams would disturb pedestrians or the drivers of other vehicles.

2. Ignition Switch Expressions

   
   

   1. The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section.

      Expression	Ignition Switch (Position)	Engine Switch (Condition)
      Ignition Switch off	LOCK	Off (Lock)
      Ignition Switch ACC	ACC	On (ACC)
      Ignition Switch ON	ON	On (IG)
      Engine Start	START	On (Start)