PRE-COLLISION SYSTEM


  1. OPERATION


    1. Warning Indication


      1. The combination meter assembly uses the multi-information display, master warning light, PCS warning light and buzzer to provide the driver with pre-collision system malfunction and indications.

      2. If the driving support ECU assembly determines that the possibility of a collision is high, it sends a signal to the combination meter assembly. Upon receiving this signal, the combination meter assembly indicates a warning using the multi-information display and skid control buzzer assembly. Details are indicated below.

        When there is a high possibility of a collision
        Multi-information Display Skid Control Buzzer Assembly
        BRAKE ! Sounds Continuously

      3. When the system is not available, the following warning occurs to warn the driver.

        When a system malfunction is detected
        Multi-information Display Detail Master Warning Light PCS Warning Light Buzzer DTC

        Pre-Collision System Malfunction

        Visit Your Dealer

        		 This message appears when the driving support ECU assembly detects a system malfunction Illuminates Illuminates Sounds once Repair is required DTCs are stored
        Pre-Collision System Unavailable

        • Millimeter wave radar sensor assembly is misaligned

        • When the millimeter wave radar sensor is hot

        • Power source voltage has decreased, etc.

        		 - Illuminates - -

        Pre-Collision System Unavailable

        Clean Sensor

        		 Dirty center mark of upper radiator grille or millimeter wave radar sensor assembly - Illuminates - -

        Front Camera Vision Blocked

        Clean and Demist Windshield

        		 Dirty or fog windshield glass over the forward recognition camera - Illuminates - -
        Front Camera Unavailable Temperature or power supply of forward recognition camera is abnormal - Illuminates - -

        VSC Turned Off

        Pre-Collision Brake System Unavailable

        		 VSC operation has been disabled - Illuminates - -

    2. Changing settings of the pre-collision system


      1. Enabling/disabling the pre-collision system


        1. The pre-collision system can be enabled/disabled on setting display screen of the multi-information display.

          Tech Tips

          The system is automatically enabled each time the engine switch is turned to IGNITION ON mode.

        2. If the system is disabled, the PCS warning light will turn on and a message will be displayed on the multi-information display.

          B004GXKC01
          *1 Steering Pad Switch Assembly - -
          *a PCS Warning Light *b Multi-information Display
          *c Enter Switch - -
          B004H73 Press on Enter Switch. - -

      2. Changing the pre-collision warning timing


        1. The pre-collision warning timing can be changed on setting display screen of the multi-information display.

          B004GZXC01
          *1 Steering Pad Switch Assembly - -
          *a Far *b Middle
          *c Near *d Enter Switch
          B004H73 Press on Enter Switch. - -

          Tech Tips


          • The pre-collision safety system is set to Middle by default.

          • When Near is selected, the warning will begin to operate later than with the default timing.

          • When Far is selected, the warning will begin to operate earlier than with the default timing.

          • The Operation timing setting is retained when the engine switch is turned off.