REAR DRIVE SYSTEM


  1. CONSTRUCTION


    1. A differential mass damper is used for the rear support point and 3-point support is given by the differential support through the cushion mount, reducing vibration and noise.

    2. 2 front support points and 1 rear support point using rubber mounts are used. The front mount is installed on the rear suspension member sub-assembly via the differential front support and the rear mount is installed on the rear suspension member sub-assembly via the differential mass damper, reducing vibration and noise.

      A01CS60C01
      *1 Front Mount *2 Differential Front Support
      *3 Rear Mount *4 Rear Suspension Member Sub-assembly
      *5 Differential Mass Damper - -
      *a A - A Cross Section *b B - B Cross Section
      B002GEN Front - -