PRE-CRASH SAFETY SYSTEM


  1. FUNCTION


    1. The combination meter assembly uses the multi-information display, master warning light, PCS warning light and multi buzzer to provide the driver with pre-crash safety system warnings and indications.

    2. If the driving support ECU assembly determines that the possibility of a collision is high, it sends a signal to the combination meter assembly. Upon receiving this signal, the combination meter assembly indicates a warning using the multi-information display, master warning light, PCS warning light and sounds skid control buzzer assembly. Details are indicated below.

      When there is a high possibility of a collision
      Multi-information Display PCS Warning Light Skid Control Buzzer Assembly
      BRAKE ! Flashes Quickly Sounds Continuously

    3. When the system is not available, the following warning occurs to warn the driver.

      When a system malfunction is detected
      Multi-information Display Detail Master Warning Light PCS Warning Light Multi Buzzer DTC

      Check

      PCS System

      		 This message appears when the driving support ECU assembly detects a system malfunction. Illuminates Flashes Sounds once

      Repair is Corresponding

      DTCs are stored

      PCS temporarily

      not available

      This message appears when the driving support ECU assembly determines either of the following conditions is present:


      • Dirty millimeter wave radar sensor assembly

      • Poor weather conditions

      After these conditions have been resolved, the system will operate normally.

      		 - Flashes - -
      When the pre-crash system cancel switch assembly is pressed
      Multi-information Display Detail Master Warning Light PCS Warning Light Multi Buzzer
      - Pre-crash safety system operation is disabled. - Illuminates -
      When the VSC OFF switch is pressed
      Multi-information Display Detail Master Warning Light PCS Warning Light Multi Buzzer

      VSC System

      Switched Off.

      Pre-crash Brake

      System

      Disengaged.

      • This message appears for 6 seconds on the multi-information display.

      • Pre-crash brake and pre-crash brake assist operation is disabled (the warning for when there is a high possibility of a collision is still enabled).

      		 - Illuminates -