SFI SYSTEM
| *1 | BRAKE ACTUATOR ASSEMBLY
|
*2 | COOLING FAN ECU |
| *3 | ECM | *4 | MASS AIR FLOW METER SUB-ASSEMBLY
|
| *5 | AIR FUEL RATIO SENSOR (Bank 1, Sensor 1) | *6 | AIR FUEL RATIO SENSOR (Bank 2, Sensor 1) |
| *7 | HEATED OXYGEN SENSOR (Bank 2, Sensor 2) | *8 | PARK/NEUTRAL POSITION SWITCH ASSEMBLY |
| *9 | HEATED OXYGEN SENSOR (Bank 1, Sensor 2) | *10 | FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY
|
| *11 | FUEL PUMP CONTROL ECU | - | - |
Figure 1. LHD Models
| *1 | COMBINATION METER ASSEMBLY | *2 | CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) |
| *3 | AIR CONDITIONING AMPLIFIER ASSEMBLY | *4 | AIRBAG SENSOR ASSEMBLY |
| *5 | STOP LIGHT SWITCH ASSEMBLY | *6 | DLC3 |
| *7 | ACCELERATOR PEDAL SENSOR ASSEMBLY | - | - |
| *a | Malfunction Indicator Lamp (MIL) | *b | Refer to Service Bulletin for the installation position of the part. |
Figure 2. RHD Models
| *A | Models with Smart Entry and Start System | - | - |
| *1 | CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) | *2 | COMBINATION METER ASSEMBLY |
| *3 | AIR CONDITIONING AMPLIFIER ASSEMBLY | *4 | AIRBAG SENSOR ASSEMBLY |
| *5 | STOP LIGHT SWITCH ASSEMBLY | *6 | ACCELERATOR PEDAL SENSOR ASSEMBLY |
| *7 | DLC3 | - | - |
| *a | Refer to Service Bulletin for the installation position of the part. | *b | Malfunction Indicator Lamp (MIL) |
| *1 | VACUUM SWITCHING VALVE ASSEMBLY (for ACIS) | *2 | CAM POSITION SENSOR (NO. 2 CRANK POSITION SENSOR) (Bank 2 Intake) |
| *3 | CAM POSITION SENSOR (NO. 2 CRANK POSITION SENSOR) (Bank 2 Exhaust) | *4 | IGNITION COIL ASSEMBLY |
| *5 | CRANK POSITION SENSOR | *6 | ENGINE COOLANT TEMPERATURE SENSOR |
| *7 | FUEL PRESSURE SENSOR (for High Pressure) | *8 | PURGE VSV |
| *9 | FUEL PUMP ASSEMBLY (for High Pressure) | *10 | CAM POSITION SENSOR (NO. 2 CRANK POSITION SENSOR) (Bank 1 Exhaust) |
| *11 | CAM POSITION SENSOR (NO. 2 CRANK POSITION SENSOR) (Bank 1 Intake) | - | - |
| *a | The illustration shown is an example only. | - | - |
| *1 | KNOCK CONTROL SENSOR (Bank 1) | *2 | KNOCK CONTROL SENSOR (Bank 2) |
| *3 | ACIS ACTUATOR | *4 | FUEL PRESSURE SENSOR (for Low Pressure) |
| *5 | FUEL INJECTOR ASSEMBLY (for Port Injection) | *6 | CAM TIMING OIL CONTROL SOLENOID ASSEMBLY (Bank 1 Intake) |
| *7 | CAM TIMING OIL CONTROL SOLENOID ASSEMBLY (Bank 1 Exhaust) | *8 | CAM TIMING OIL CONTROL SOLENOID ASSEMBLY (Bank 2 Intake) |
| *9 | WATER INLET WITH THERMOSTAT SUB-ASSEMBLY
|
*10 | CAM TIMING OIL CONTROL SOLENOID ASSEMBLY (Bank 2 Exhaust) |
| *11 | FUEL INJECTOR ASSEMBLY (for Direct Injection) | *12 | THROTTLE BODY WITH MOTOR ASSEMBLY
|
| *a | The illustration shown is an example only. | - | - |
 |
Engine Front | - | - |