PRE-CRASH SAFETY SYSTEM


  1. OPERATION


    1. Pre-crash System Cancel Switch Assembly


      1. A pre-crash system cancel switch assembly is provided to disable the system. When pressed and held for approximately 3 seconds, the pre-crash safety system will be disabled. A message will be displayed for 6 seconds and the PCS warning light will be illuminated. When the switch is pressed again while the system is disabled, the system will be re-enabled.

      2. The switch is also used to change the warning timing in 3 levels: far, middle, near. The warning timing changes in the order below each time the switch is pressed.

        Figure 1. Select of Warning Timing

        A01SF5OE05