ELECTRONIC SHIFT LEVER SYSTEM


  1. CONSTRUCTION


    1. The shift lever position sensors for detecting the shift lever position (R, N, D or B) are built into the transmission floor shift assembly.

    2. The shift lever position sensor consists of a select sensor that detects the lateral movement of the shift lever, and a shift sensor that detects the longitudinal movement of the shift lever.

    3. The select sensor and the shift sensor uses Hall ICs for position detection.

    4. The select sensor and shift sensor Hall ICs each contain 2 circuits, one for the main signal, and one for the sub signal. It converts the shift position into electric signals that have differing characteristics and outputs them to the power management control ECU.

      A00Z03AC03
      *1 Shift Lever Position Sensor (Select Sensor) *2 Shift Lever Position Sensor (Shift Sensor)
      *3 Magnet Slider *4 Hall IC
      *5 Magnet Yoke - -
      A00Z0DGE05
      A00Z0BTE07

    5. The power management control ECU selects the shift position in accordance with the combination of signals from the select sensor and the shift sensor as shown in the following table.

      Selected Shift Position

      Select Sensor Detection Position

      (Lateral Movement)

      Shift Sensor Detection Position

      (Longitudinal Movement)
      R R-N-D Side R Side
      N R-N-D Side Home Position
      D R-N-D Side B-D Side
      B Home Position B-D Side