ЗАПУСК И ОСТАНОВ


  1. OPERATION


    1. The combination meter assembly receives the idling on/off signals from the engine stop and start ECU.

    2. By changing the display mode of the multi-information display, the amount of time idling stop was performed since the ignition switch was turned ON to when the ignition switch was turned off or the amount of time idling stop was performed since the reset switch was last pressed can be displayed.

    3. The system operation status or warning information is indicated to the driver through the following means:


      • Illuminating or flashing the stop and start indicator light and stop and start cancel indicator light on the multi-information display in the combination meter assembly.

      • Sounding a buzzer.

      • Displaying other information on the multi-information display.

      A01KV2TC01
      *a Stop and Start Indicator Light *b Stop and Start Cancel Indicator Light
      *c Multi-information Display - -
      Stop and Start Indicator Light Operation
      Item Condition Stop and Start Indicator Light Buzzer
      System Operating (Engine is stopped) The vehicle is operating normally. Illuminates Does not sound
      The shift lever is operated without depressing the clutch pedal. Blinks* Sounds

      *: The blinking interval is 0.3 seconds.

      Stop and Start Cancel Indicator Light Operation
      Condition Stop and Start Cancel Indicator Light
      The vehicle is stopped and system operation conditions are met. OFF
      While the stop and start system is preventing the engine stop control from operating. Illuminates
      When the ecorun cancel switch assembly is ON.
      When any Diagnostic Trouble Code (DTCs) are detected. Blinks*
      When the number of times the starter assembly has been operated exceeds the threshold.

      *: The blinking interval is 0.15 seconds.

      Multi-information Display Operation
      Display Operation Condition Multi-information Display
      System Malfunction Display A system malfunction is detected.

      Stop & Start

      system malfunction.

      Inspect at dealer.
      Display of Temporary Cancellation of Idling Stop Operation The driver's seatbelt is unfastened during idling stop. Driver seat belt unbuckled.
      The driver operates the steering wheel more than a specified angle during idling stop. Steering wheel turned.
      Hydraulic pressure of brakes becomes insufficient during idling stop. For brake system.
      Cooling performance of the air conditioning system deteriorates during idling stop. For climate control.
      Battery charge amount decreases during idling stop. Battery charging.
      The hood is opened during idling stop. Bonnet open.
      Display of Prohibition Status of Engine Restart during Idling Stop Operation The shift lever is moved from N to another position without depressing the clutch pedal.

      Stop & Start system active.

      Shift to N and depress

      clutch to restart.
      Display of Prohibition Status of Stop and Start Control Battery charge amount decreases and becomes insufficient for the engine stop requirements. Battery charging.
      Hydraulic pressure of brakes is insufficient. For brake system.
      The driver's seatbelt is not fastened. Driver seat belt unbuckled.
      The air conditioning system is being used. For climate control.
      The engine has been started with the hood opened. Bonnet open.
      Display of Standby State of Stop and Start Control Brake pedal depression is insufficient for the engine stop requirement. Depress brake firmly to activate.