MONITOR SYSTEM


  1. FUNCTION OF MAIN COMPONENTS

    Component Function
    Rear Television Camera Assembly Transmits a video signal of the area behind the vehicle to the radio and display receiver assembly.
    Radio and Display Receiver Assembly

    • Receives signals from the park/neutral position switch assembly*1 or back-up light switch assembly*2, and turns the rear television camera assembly on and off.

    • Displays the image transmitted by the rear television camera assembly on the screen.
    Park/Neutral Position Switch Assembly*1 Sends a shift R position signal to the radio and display receiver assembly.
    Back-up Light Switch Assembly*2

    *1: Models with multidrive/continuously variable transaxle

    *2: Models with manual transaxle or multi-mode manual transaxle

  2. FUNCTION


    1. This system operates when both the following conditions have been met:


      1. Ignition switch is ON.

      2. Shift lever is in R.

    2. Area Displayed on Screen


      1. On the display, objects on the right of the vehicle appear on the right side of the display panel, and objects on the left of the vehicle appear on the left side of the display panel.

      2. The rear television camera uses a wide-angle lens. The perceived distance from images that appear on the screen differs from the actual distance.

        A00XRFE

        Note

        The area displayed on the screen may vary according to vehicle status or road conditions. The area covered by the rear television camera assembly is limited. The rear television camera assembly does not show objects close to either corner of the bumper or show the area under the bumper.

    3. Warning Message


      1. A warning message appears at the bottom of the screen under the following condition. The warning message appears in the same language that has been selected by the language selector of the multi-display.

        Message Appearing at Bottom of Screen
        Warning Message Condition
        Check surroundings for safety. This message always appears during system operation.

  3. FAIL-SAFE


    1. The table below indicates fail-safe operation when a malfunction is detected:

      Malfunctioning Part Detection Item Function
      Rear Television Camera Assembly Rear television camera assembly malfunction signal is detected. System stops signal reception and displays a dark screen.