OPERATION
The combination meter assembly receives the idling on/off signals from the engine stop and start ECU.
By changing the display mode of the multi-information display, the amount of time idling stop was performed since the ignition switch was turned ON to when the ignition switch was turned off or the amount of time idling stop was performed since the reset switch was last pressed can be displayed.
The system operation status or warning information is indicated to the driver through the following means:
Illuminating or flashing the stop and start indicator light and stop and start cancel indicator light on the multi-information display in the combination meter assembly.
Sounding a buzzer.
Displaying other information on the multi-information display.
| *a | Stop and Start Indicator Light | *b | Stop and Start Cancel Indicator Light |
| *c | Multi-information Display | - | - |
| Item | Condition | Stop and Start Indicator Light | Buzzer |
|---|---|---|---|
| System Operating (Engine is stopped) | The vehicle is operating normally. | Illuminates | Does not sound |
| The shift lever is operated without depressing the clutch pedal.*1 | Blinks*3 | Sounds | |
| The driver's door is opened with the shift lever in D or M.*2 | Blinks*3 | Sounds |
*1: Models with manual transaxle
*2: Models with multidrive/continuously variable transaxle
*3: The blinking interval is 0.15 seconds.
| Condition | Stop and Start Cancel Indicator Light |
|---|---|
| The vehicle is stopped and system operation conditions are met. | OFF |
| While the stop and start system is preventing the engine stop control from operating. | Illuminates |
| When the ecorun cancel switch assembly is ON. | |
| When any Diagnostic Trouble Code (DTCs) are detected. | Blinks* |
| When the number of times the starter assembly has been operated exceeds the threshold. |
*: The blinking interval is 0.5 seconds.
| Stop and Start System Condition | Multi-information Display Message | Vehicle Condition | |
|---|---|---|---|
| When the engine cannot be stopped by the stop and start system | |
"For Climate Control" |
|
| "Battery Charging" |
|
||
| "For Brake System" |
|
||
| "Bonnet open" | The engine has been started with the hood opened. | ||
| "Driver Seat Belt Unbuckled" | The driver seat belt is not fastened. | ||
| "Non-Dedicated Battery" | When a battery that is not specified is used and the battery voltage is below the lowest engine starting voltage. | ||
| When the engine automatically restarts while stopped by the atop and start system | |
"For Climate Control" |
|
| "For Brake System" | The brake pedal is strongly depressed further or pumped. | ||
| "Battery Charging" | The battery charge amount may be low. | ||
| "Steering Wheel Turned" | The steering wheel is turned. | ||
| "Bonnet open" | The hood is opened during idling stop. | ||
| "Driver Seat Belt Unbuckled" | The driver seat belt is not fastened. | ||
| Display of prohibition Status of Engine Restart during idling stop Operation* | - | "Stop & start system active" "Shift to N and depress" "clutch to restart" |
The shift lever is moved from N to another position without depressing the clutch pedal. |
| Stop and start system may be malfunctioning | - | "Stop & Start System Malfunction" "Inspect at dealer" |
- |
*: Models with manual transaxle