SFI SYSTEM


  1. CONSTRUCTION


    1. The non-contact type accelerator pedal sensor assembly uses a Hall IC.

    2. The magnetic yoke mounted at the base of the accelerator pedal arm moves around the Hall IC in accordance with the amount of effort applied to the accelerator pedal. The Hall IC converts the changes in the magnetic flux that occur into electrical signals, and outputs them in the form of accelerator pedal effort to the ECM.

    3. This accelerator pedal sensor assembly includes 2 Hall ICs and circuits for the main and sub signals. It converts the accelerator pedal opening angles into electric signals with two differing characteristics and outputs them to the ECM.

    4. On models with the cruise control system, when the accelerator pedal opening angle is greater than a predetermined amount, the ECM detects a "kick down mode" request through the VPA signal sent by the accelerator pedal sensor assembly.

      Figure 1. Models with Kick Down Mode

      A00XRDUE03

      Figure 2. Models without Kick Down Mode

      A00XRJPE04