PRE-COLLISION SYSTEM


  1. OPERATION


    1. Warning Indication


      1. The combination meter assembly uses the multi-information display, master warning light, PCS warning light and buzzer to provide the driver with pre-collision system malfunction and indications.

      2. If the driving support ECU assembly determines that the possibility of a collision is high, it sends a signal to the combination meter assembly and buzzer. Upon receiving this signal, the combination meter assembly indicates a warning using the multi-information display and buzzer sounds. Details are indicated below.

        When there is a high possibility of a collision
        Multi-information Display Buzzer
        BRAKE ! Sounds Continuously

      3. When the system is not available, the following warning occurs to warn the driver.

        When a system malfunction and unavailable are detected
        Multi-information Display Detail Master Warning Light PCS Warning Light Buzzer DTC
        Pre-Collision System Malfunction Visit Your Dealer This message appears when the driving support ECU assembly detects a system malfunction. Illuminates Illuminates Sounds once Repair is required DTCs are stored
        Pre-Collision System Unavailable

        • Millimeter wave radar sensor assembly is misaligned

        • When the millimeter wave radar sensor assembly is hot

        • Power source voltage has decreased, etc.

        		 - Illuminates - -
        Pre-Collision System Unavailable Clean Sensor Dirty center mark of upper radiator grille or millimeter wave radar sensor assembly - Illuminates - -
        Front Camera Vision Blocked Clean and Demist Windshield Dirty windshield glass over the camera sensor - Illuminates - -
        Front Camera Unavailable Temperature or power supply of camera sensor is abnormality - Illuminates - -
        Front Camera Unavailable Remove Debris On Windshield Debris on area of windshield glass in front of forward recognition camera - Illuminates - -
        VSC Turned Off Pre-Collision Brake System Unavailable VSC operation have been disabled - Illuminates - -

    2. Changing settings of the pre-collision system


      1. Enabling/disabling the pre-collision system


        1. The pre-collision system can be enabled/disabled on setting display screen of the multi-information display.


          1. On the setting display screen, select PCS icon (PCS warning light same design) and then press on Enter/Set switch of the steering pad switch assembly.

          2. Select the [PCS] and then press on Enter/Set switch of the steering pad switch assembly.

          3. Select the [ON] / [OFF] on the screen and press on Enter/Set switch of the steering pad switch assembly, the system will be enabled/disabled.

            B003XJQC01
            *A F SPORT *B Except F SPORT
            *a Normal Mode *b Menu Mode
            *c PCS warning Light *d Multi-information Display
            *e

            Steering Pad Switch Assembly


            • Meter Control Switches

            		 - -

        Tech Tips


        • If the system is disabled, the PCS warning light will turn on and a message will be displayed on the multi-information display.

        • The system is automatically enabled each time the power switch is turned to ON mode.

      2. Changing the pre-collision warning timing


        1. The pre-collision warning timing can be changed on setting display of the multi-information display.


          1. On the setting display screen, select PCS icon (PCS warning light same design) and then press on Enter/Set switch of the steering pad switch assembly.

          2. Select [Sensitivity] and then press on Enter/Set switch of the steering pad switch assembly.

          3. Select the operation timing icon (Far/Middle/Near) on the screen and press on Enter/Set switch of the steering pad switch assembly, warning timing of the pre-collision system will be changed.

            B003XL2C01
            *A F SPORT *B Except F SPORT
            *a Menu Mode *b Far
            *c Middle *d Near
            *e

            Steering Pad Switch Assembly


            • Meter Control Switches

            		 - -