PRE-COLLISION SYSTEM


  1. OPERATION


    1. Warning Indication


      1. The combination meter assembly uses the multi-information display, master warning light, PCS warning light and buzzer to provide the driver with pre-collision system malfunction and indications.

      2. If the driving support ECU assembly determines that the possibility of a collision is high, it sends a signal to the combination meter assembly and skid control buzzer assembly. Upon receiving this signal, the combination meter assembly indicates a warning using the multi-information display and skid control buzzer assembly sounds. Details are indicated below.

        When there is a high possibility of a collision
        Multi-information Display Skid Control Buzzer Assembly
        BRAKE ! Sounds Continuously

      3. When the system is not available, the following warning occurs to warn the driver.

        When a system malfunction is detected
        Multi-information Display Detail Master Warning Light PCS Warning Light Buzzer DTC
        Pre-Collision System Malfunction Visit Your Dealer This message appears when the driving support ECU assembly detects a system malfunction. Illuminates Flashes Sounds once Repair is required DTCs are stored
        Pre-Collision System Unavailable

        • Millimeter wave radar sensor assembly is misaligned

        • When the millimeter wave radar sensor assembly is hot

        • Power source voltage has decreased, etc.

        		 - Flashes - -
        Pre-Collision System Unavailable Clean Sensor Dirty center mark of upper radiator grille or millimeter wave radar sensor assembly - Flashes - -
        Forward Camera System Unavailable Clean Windshield Dirty windshield glass over the camera sensor - Flashes - -
        Forward Camera System Unavailable Temperature or power supply of camera sensor is abnormality - Flashes - -
        VSC Turned Off Pre-Collision Brake System Unavailable VSC operation have been disabled - Illuminates - -

    2. Changing settings of the pre-collision system


      1. To change the enabled or disabled of the pre-collision system using the multi-information display and the steering pad switch assembly (meter control switches), display the setting display screen.


        1. On the setting display screen, select PCS icon (PCS warning light same design) and then press on Enter/Set switch of the steering pad switch assembly.

        2. Select the [PCS] and then press on Enter/Set switch of the steering pad switch assembly.

        3. Select the [ON] / [OFF] on the screen and press on Enter/Set switch of the steering pad switch assembly, the system will be enabled/disabled.

          B003SGLC01
          *A F SPORT *B except F SPORT
          *a Normal Mode *b Menu Mode
          *c PCS warning Light *d Multi-information Display
          *e

          Steering Pad Switch Assembly


          • Meter Control Switches

          		 - -

        Tech Tips


        • If the system is disabled, the PCS warning light will turn on and a message will be displayed on the multi-information display.

        • The system is automatically enabled each time the engine switch is turned to ON.

      2. The pre-collision warning timing can be changed on setting display of the multi-information display.


        1. On the setting display screen, select PCS icon (PCS warning light same design) and then press on Enter/Set switch of the steering pad switch assembly.

        2. Select [Sensitivity] and then press on Enter/Set switch of the steering pad switch assembly.

        3. Select the operation timing icon (Far/Middle/Near) on the screen and press on Enter/Set switch of the steering pad switch assembly, warning timing of the pre-collision system will be changed.

          B003SJKC01
          *A F SPORT *B except F SPORT
          *a Menu Mode *b Far
          *c Middle *d Near
          *e

          Steering Pad Switch Assembly


          • Meter Control Switches

          		 - -