PRE-COLLISION SYSTEM


  1. OPERATION


    1. Warning Indication


      1. The combination meter assembly uses the multi-information display, master warning light, PCS warning light and buzzer to provide the driver with pre-collision system malfunction and indications.

      2. If the driving support ECU assembly determines that the possibility of a collision is high, it sends a signal to the combination meter assembly and buzzer. Upon receiving this signal, the combination meter assembly indicates a warning using the multi-information display and buzzer sounds. Details are indicated below.

        When there is a high possibility of a collision
        Multi-information Display Skid Control Buzzer Assembly
        BRAKE ! Sounds Continuously

      3. When the system is not available, the following warning occurs to warn the driver.

        When a system malfunction is detected
        Multi-information Display Detail Master Warning Light PCS Warning Light Buzzer DTC
        Pre-Collision System Malfunction Visit Your Dealer This message appears when the driving support ECU assembly detects a system malfunction. Illuminates Illuminates Sounds once Repair is required DTCs are stored
        Pre-Collision System Unavailable

        • Millimeter wave radar sensor assembly is misaligned

        • When the millimeter wave radar sensor assembly is hot

        • Power source voltage has decreased, etc.

        		 - Illuminates - -
        Pre-Collision System Unavailable Clean Sensor Dirty center mark of upper radiator grille or millimeter wave radar sensor assembly - Illuminates - -
        Front Camera Vision Blocked Clean and Demist Windshield Dirty windshield glass over the camera sensor - Illuminates - -
        Front Camera Unavailable Temperature or power supply of forward recognition camera is abnormality - Illuminates - -
        Front Camera Unavailable Remove Debris On Windshield Debris on area of windshield glass in front of forward recognition camera - Illuminates - -
        VSC Turned Off Pre-Collision Brake System Unavailable VSC operation have been disabled - Illuminates - -

    2. Changing settings of the pre-collision system


      1. Enabling/disabling the pre-collision system


        1. The pre-collision system can be enabled/disabled on setting display screen of the multi-information display.

          Tech Tips

          The system is automatically enabled each time the engine switch is turned to IGNITION ON mode.

        2. If the system is disabled, the PCS warning light will turn on and a message will be displayed on the multi-information display.

          B003SGDC01
          *A F SPORT *B except F SPORT
          *a Normal Mode *b Menu Mode
          *c PCS warning Light *d Multi-information Display
          *e

          Steering Pad Switch Assembly


          • Meter Control Switches

          		 - -

      2. Changing the pre-collision warning timing


        1. The pre-collision warning timing can be changed on setting display of the multi-information display.

          B003SJKC01
          *A F SPORT *B except F SPORT
          *a Menu Mode *b

          Far


          • The warning will begin to operate earlier than with the default timing.
          *c

          Middle


          • This is the default setting.

          		 *d

          Near


          • The warning will begin to operate later than with the default timing.
          *e

          Steering Pad Switch Assembly


          • Meter Control Switches

          		 - -

          Tech Tips

          The operation timing setting is retained when the engine switch is turned off.