PRE-CRASH SAFETY SYSTEM


  1. FUNCTION


    1. The combination meter assembly uses the multi-information display, master warning light, PCS warning light and multi buzzer to provide the driver with pre-crash safety system warnings and indications.

    2. If the driving support ECU assembly determines that the possibility of a collision is high, it sends a signal to the combination meter assembly. Upon receiving this signal, the combination meter assembly indicates a warning using the multi-information display, master warning light, PCS warning light and skid control buzzer assembly. Details are indicated below.

      When there is a high possibility of a collision
      Multi-information Display PCS Warning Light Skid Control Buzzer Assembly
      BRAKE ! Flashes Sounds continuously

    3. When the system is not available, the following warning occurs to warn the driver.

      When a system malfunction is detected
      Multi-information Display Detail Master Warning Light PCS Warning Light Multi Buzzer DTC

      Check

      PCS System

      		 This message appears when the driving support ECU assembly detects a system malfunction. Illuminates Flashes Sounds once

      Repair is required

      DTCs are stored

      PCS temporarily

      not available

      This message appears when the driving support ECU assembly determines the following conditions:


      • Dirty millimeter wave radar sensor assembly

      • Poor weather condition

      After these conditions have been resolved, the system will operate normally.

      		 - Flashes - -
      When the pre-crash system cancel switch assembly is pressed
      Multi-information Display Detail Master Warning Light PCS Warning Light Multi Buzzer
      - Pre-crash safety system operation is disabled. - Illuminates -
      When the VSC OFF switch is pressed
      Multi-information Display Detail Master Warning Light PCS Warning Light Multi Buzzer

      VSC System

      Switched Off.

      Pre-crash Brake

      System

      Disengaged.

      • This message appears for 6 seconds on the multi-information display.

      • Pre-crash brake and pre-crash brake assist operation is disabled (a warning that occurs when there is a high possibility of a collision is still enabled).

      		 - Illuminates -