SLIDING ROOF SYSTEM GENERAL


  1. OUTLINE


    1. A multi-panel type or inner-slide type sliding roof system is available.

    2. The inner-slide type sliding roof system uses a glass panel to perform tilt up-and-down and open-and-close operations.

    3. The multi-panel type sliding roof system uses 1 panel and 2 glass panels. This system creates a cabin with a sense of openness.

    4. The sliding roof ECU controls the sliding roof system. This ECU uses 2 Hall ICs to detect the position of the glass panel(s). The sliding roof ECU and the 2 Hall ICs are integrated in the sliding roof drive gear sub-assembly.

      A01GVX2E01
      Text in Illustration (Models with Multi-panel Type Sliding Roof:)
      *1 Front Panel (Sliding Roof Panel Sub-assembly) *2 Center Glass Panel (Sliding Roof Glass Sub-assembly)
      *3 Rear Glass Panel (Sliding Roof Housing Panel) - -
      A01GVWKE01
      Text in Illustration (Models with Inner-slide Type Sliding Roof:)
      *1 Sliding Roof Glass Sub-assembly - -

  2. MAJOR DIFFERENCE


    1. This manual has been modified from the previous manual as shown below:


      1. RHD models have been added.

  3. PRECAUTION


    1. Door Control Receiver Expressions


      1. The type of door control receiver used on this model differs according to the specifications of the vehicles. The expressions listed in the table below are used in this section.

        Vehicle Specification Part Name in Manual Actual Part Name
        Models with Tire Pressure Warning System Integrated Door Control Receiver and Tire Pressure Warning ECU and Receiver Door Control Receiver Door Control and Tire Pressure Monitoring System Receiver Assembly
        Separate Door Control Receiver and Tire Pressure Warning ECU and Receiver Door Control Receiver Door Control Receiver
        Models without Tire Pressure Warning System Door Control Receiver Door Control Receiver