STARTING SYSTEM GENERAL


  1. OUTLINE


    1. P0.8 type starter is used.

    2. P1.0 type starter is used on cold area specification models.

    3. P0.8 and P1.0 types are available for the conventional planetary reduction type starter.

    4. Cranking hold function is used for models with entry and start system. Once the engine switch is pressed, this control operates the starter until the engine starts.

      A0116O1E02
      Text in Illustration (P0.8 Type:)
      *a Length - -
      A0116EAE02
      Text in Illustration (P1.0 Type:)
      *a Length - -

  2. SPECIFICATION

    Starter Type

    P 0.8

    (Planetary Redaction Type)

    P 1.0*

    (Planetary Redaction Type)
    Length mm (in.) 143.8 (5.66) 153.8 (6.06)
    Weight g (lb) 2950 (6.50) 3150 (6.95)
    Rating Voltage V 12 ←
    Rating Output kW 0.8 1.0
    Rotating Direction (Viewed from pinion side) Clockwise ←

    • *: Cold area specification models

  3. PRECAUTION


    1. Cranking hold function has following safety features:


      1. While the engine is running normally, the starter does not operate.

      2. Even if the driver keeps pressing the engine switch, the power management control ECU stops the output of the STAR and ACCD signals when the engine speed becomes higher than 1200 rpm. Thus, the starter operation stops and the power management control ECU energizes the ACC relay.

      3. In case the driver keeps pressing the engine switch and the engine does not start, the power management control ECU stops the output of the STAR and ACCD signals after 30 seconds have elapsed. Thus, the starter operation stops and the power management control ECU energizes the ACC relay.

      4. In case the power management control ECU cannot detect an engine speed signal while the starter is operating, the ECM will immediately stop the output of the STAR and ACCD signals. Thus, the starter operation stops and the power management control ECU energizes the ACC relay.