FRONT SUSPENSION CROSSMEMBER(for AWD) DISTANCE FROM CENTER LINE / DATUM PLANE
Tech Tips
-
Length measurements are indicated at the points where the arrows extending from the zero point intersect the lines that extend towards the outside of the illustration from each point.
-
In cases in which only one dimension is given, left and right are symmetrical.
-
For symbols, capital letters indicate right side of vehicle, small letters indicate left side of vehicle (seen from rear).
| Symbol | Name | Hole Diameter mm (in.) |
|---|---|---|
| A, a | Front Frame Installation Hole | 29x24.5 (1.14x0.96) |
| B, b | Front Frame Standard Hole | φ13 (0.51) |
| C, c | Front Suspension Lower Arm Front Installation Hole | 17x10 (0.67x0.39) |
| D, d | Front Suspension Lower Arm Front Installation Hole | 17x10 (0.67x0.39) |
| E, e | Front Frame Standard Hole | φ14 (0.55) |
| F, f | Front Suspension Lower Arm Rear Installation Hole | 29x21.2 (1.14x0.83) |
| G, g | Front Suspension Lower Arm Rear Installation Hole | 29x21.2 (1.14x0.83) |
| H, h | Front Frame Standard Hole | φ10 (0.39) |
| J, j | Front Frame Installation Hole | φ24 (0.94) |
| *a | mm (in.) |
- | - |
| *a | Imaginary Datum Line | *b | Height from Imaginary Datum Line |
| *c | mm (in.) |
- | - |