UNDER BODY REFERENCE VALUES(for AWD) POINT-TO-POINT DISTANCE
Tech Tips
-
Measure points with the engine under cover No.1, engine under cover No.2, engine side cover and floor board sub-assembly removed.
-
In cases in which only one dimension is given, left and right are symmetrical.
-
For symbols, capital letters indicate right side of vehicle, small letters indicate left side of vehicle (seen from rear).
| Symbol | Name | Hole Diameter mm (in.) |
|---|---|---|
| A, a | Front Crossmember Lower Standard Hole | φ18 (0.71) |
| B, b | Front Suspension Crossmember Installation Bolt | - |
| C, c | Lower Arm Mounting Reinforcement Standard Hole | φ10 (0.39) |
| D, d | Front Side Member Reinforcement No.5 Standard Hole | φ18 (0.71) |
| *a | mm (in.) |
- | - |
Tech Tips
-
Measure points with the floor board sub-assembly, rear floor side member cover, differential support protector and floor under cover No.1 removed.
-
In cases in which only one dimension is given, left and right are symmetrical.
-
For symbols, capital letters indicate right side of vehicle, small letters indicate left side of vehicle (seen from rear).
| Symbol | Name | Hole Diameter mm (in.) |
|---|---|---|
| A, a | Front Floor Brace Installation Bolt | M8 (0.31) |
| B, b | Rear Floor Side Member Standard Hole | φ18 (0.71) |
| C, c | Rear Suspension Crossmember Installation Bolt | M14 (0.55) |
| D, d | Rear Suspension Crossmember Installation Bolt | M14 (0.55) |
| E, e | Rear Floor Panel Reinforcement Standard Hole | φ10 (0.39) |
| *a | mm (in.) |
- | - |