LUGGAGE DOOR THREE-DIMENSIONAL DISTANCE
Tech Tips
-
Point L, l on the vehicle are asymmetrical.
-
In cases in which only one dimension is given, left and right are symmetrical.
-
For symbols, capital letters indicate right side of vehicle, small letters indicate left side of vehicle (seen from rear).
| Symbol | Name | Hole Diameter mm (in.) |
|---|---|---|
| A, a | Roof Panel Corner | - |
| B, b | Front Side Outer Panel Standard Hole | φ13X10 (0.51X0.39) |
| C | Upper Back Reinforcement Center Mark | - |
| D, d | Luggage Compartment Opening Trough Corner | - |
| E, e | Luggage Door Hinge Installation Nut | M8 (0.31) |
| F, f | Luggage Door Hinge Installation Nut | M8 (0.31) |
| G, g | Front Side Outer Panel Standard Hole | φ13 (0.51) |
| H, h | Quarter Panel Extension Outer Corner | - |
| J, j | Quarter Panel Extension Outer Corner | - |
| K, k | Rear Finish Plate Installation Hole | φ8.5 (0.33) |
| L, l | Luggage Door Lock Striker Installation Nut | M8 (0.31) |
| M, m | Rear Bumper Reinforcement Installation Nut | M8 (0.31) |
| N, n | Rear Floor Side Member Rear Standard Hole | φ18 (0.71) |
| O, o | Rear Floor Side Member Rear Standard Hole | φ18 (0.71) |
| P, p | Rear Spring Support Installation Hole | φ13 (0.51) |
| Q, q | Roof Side Rail Assembly Mark | - |
| *A | for Glass Roof | - | - |
| *a | Distance between points other than those above | *b | mm (in.) |
| *A | for Carbon Fiber Reinforced Plastic Roof | - | - |
| *a | Distance between points other than those above | *b | mm (in.) |